|
|
|
Who's Online
There currently are 5400 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
;
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
 ;
The owners manual is very good. all my how to questions were answered in detail.
;
Irrespectively of this manual exist only germany language, it's useful - although i need some additional task to translate: My english is bad, but usable - but i really dont speak germany. :)
;
Excellent service from this company (including a total refund on an earlier purchase when through no fault of the company the manual was incomplete). I have purchased several manuals which I have been very satisfied with, as I am with this one. Highly recommended.
Conversion from Natural to LPG Gas
IMPORTANT The replacement/conversion of the gas hob should only be undertaken by a CORGI registered engineer. It is important to note that this model is designed for use with natural gas but can be converted for use with butane or propane gas providing the correct injectors are fitted. The gas rate is adjusted to suit. Method � Ensure that the gas taps are in the 'OFF' position � � � Isolate the hob from the electricity supply Remove all pan supports, burner caps, rings, crowns and control knobs. With the aid of a 7mm box spanner the burner injectors can then be unscrewed and replaced by the appropriate LPG injectors.
Replacement of gas oven burner nozzle
To replace the gas oven nozzle, follow this procedure: a) remove the bottom of the oven; b) undo screw 1 and take the oven burner out; c) with a socket spanner 7 unscrew and remove the nozzle, situated in the bottom of the oven, and replace it with the proper one (see Table on page 18); d) reassemble the burner following the same procedure backwards.
TO ADJUST THE GAS RATE With the aid of a thin bladed screwdriver undo the by pass screw about 1/4 of a turn (45°). Upon completion stick the replacement rating plate near the gas supply pipe.
Minimum level adjustment of gas oven burner
After setting the oven on maximum temperature with door closed for about 10 minutes, turn the knob on minimum. To reach the thermostat by-pass screw and adjust the minimum level, act as follows: � take out the knobs; � remove the front panel; � in case of conversion from natural gas to LPG, tightly screw the by-pass screw of thermostat (see fig.); � to convert from LPG to natural gas, unscrew the bypass screw, until a regular small flame is reached. � finally check that turning quickly the tap from maximum position to minimum position, the flame does not go out; � reassemble the front panel and the knobs. The oven burner does not need any primary air regulation.
FO 1061
22
|
|
|
> |
|
